Functions of the multispectral sensor button
Use the button to enable/disable burst mode, take photos and enable/ disable Wi-Fi on Sequoia. Note: Sequoia must be turned on to activate these features.
1 click | Take a photo |
2 clicks | Enable/disable shots |
4 clicks | Enable/disable Wi-Fi |
Hold down (3 seconds) | Switch off Sequoia |
Disconnect the multispectral
Press and hold the Sequoia button for 3 seconds to turn it off. The indicator light goes out. If you disconnect Sequoia while the indicator is still on the latest photos may be corrupted.
LED properties
Multispectral sensor Start up
When you turn on Sequoia the LED has the following properties:
Other
LED properties |
Meaning |
Quick flashing orange |
Shutting down |
Slow flashing orange |
Update in progress |
Flashing blue |
Enabling/Disabling Wi-Fi |
Problem |
|
Flashing red |
Hardware malfunction |
Flashing red |
Corrupted memory. Repair in progress. Once the repair is complete the LED reverts to green. This operation may take several seconds depending on the space available on your SD card. |
Flashing Yellow |
SD card full |
Calibration |
|
Flashing purple |
Calibration in progress (yaw axis) |
Flashing green | Calibration in progress (pitch axis) |
Flashing cyan | Calibration in progress (roll axis) |
Photo Shoot | |
Continuous blue | Shot being taken |
Continuous light green | At least one of the four sensors is enabled |
Sunshine Sensor
LED properties |
Meaning |
Problem |
|
Continuous red |
Hardware malfunction |
Flashing yellow |
SD Card full |
Calibration |
|
Flashing purple |
Calibration in progress (yaw axis) |
Flashing green |
Calibration in progress (pitch axis) |
Flashing cyan |
Calibration in progress (roll axis) |
GPS/GNSS |
|
Continuous yellow |
GPS /GNSS connection not established |
Continuous green |
GPS /GNSS connection established |