RedEdge Manual > Getting Started > Connections

 

Insert SD Card

Insert SD card, label side facing up, until it clicks into place.

To remove SD card, press the edge of the card until the spring mechanism unlatches.

 

NOTE

An SDHC Class 10 SD card with a write-speed capability of at least 45 MB/s is required (32 GB SanDisk Extreme recommended). SDXC SD cards are not compatible with the RedEdge camera.

 

 

Connect GPS Module

 

If stand-alone GPS module is used:

Connect one end of 6-pin cable to camera connector labeled “GPS”.

Connect other end of 6-pin cable to GPS module connector labeled “GPS”.

For more advanced integrations where GPS data is provided by the autopilot or other GPS source, refer to RedEdge Integration Guide.

To remove connectors, do not pull on wires; instead use a small flathead screwdriver to pry out the connector. See Section 5.

 

                                                                  CAUTION               

Always connect the GPS module to the camera before turning on the camera. Failure to do so may damage the GPS module.

Connect Power Cable

 

Refer to RedEdge Integration Guide for details on power requirements and connector pinout.

Connect power cable to connector labeled “PWR/TRIG”.

To remove connector, do not pull on wires; instead use a small flathead screwdriver to pry out the connector. See Section 5.

 

                                                                  CAUTION               

Power must not exceed 5.5 V DC. Ensure correct pinout and polarity before connecting power. Failure to follow these instructions may result in permanent damage to the camera.

Have more questions? Submit a request