How to Test a Storage Device Using a MicaSense Sensor

To test the storage device on the ground or in the lab, you will need a stopwatch.

  • Place the camera in timer mode with a period of 0.5 seconds. (How?)
  • Start both the stopwatch and timer mode at the same time.
  • Press stop on both the timer mode and the stopwatch after at least 10 minutes, but before the card is full.
  • Check the number of images written to the storage device. (How?)
    • If there is more than one folder, there are 200 images in each folder (except the last). For the last folder, look for the highest-numbered image in the last folder and add that to the count. For example, if "002" is the last folder, folders 000 and 001 would each have 200 images. In the last folder, 002/IMG_0185_1.tif would be image number 185. The number of images would be 200*2 + 185 (or 585).
    • Divide this number by the number of seconds the camera was allowed to run, and this provides the average capture rate the storage device can sustain.
    • The resulting number should be greater than or equal to 1. If it is less than 1, the storage device may not be suitable for use. Replace it with our recommended SD card for RedEdge or a USB 3.0 SSD or other fast storage device for Altum.

NOTE: Altum has an additional consideration. Every 5 minutes or 2 degree change in temperature, the thermal camera needs to recalibrate, which takes a few seconds (about 3 seconds). This could delay capture times in some instances. 

Have more questions? Submit a request